Home
Get it going
Latest images
Register
Log inSearch
Latest topics
ipv6 unnumbered fax/y or ipv6 enable command?
Page 1 of 1
ipv6 unnumbered fax/y or ipv6 enable command?
Admin Thu Jun 11, 2009 1:14 pm
I was wandering why i would use the ipv6 unnumbered command on a tunnel interface when actually using the ipv6 enable command would to my understanding, provide a link-local address for the tunnel interface.
when I use the ipv6 enabled command and then run any routing protocol, it works but some other peaple would use the ipv6 unnumbered command.
Are this the same or there is any major difference
when I use the ipv6 enabled command and then run any routing protocol, it works but some other peaple would use the ipv6 unnumbered command.
Are this the same or there is any major difference
Admin- Admin
- Posts : 24
Join date : 2009-06-04 -
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum|
|
|
» Ruhann short notes
» CCIE__CERT- R&S ver 4, SP inc new Labs, SEC ver 3
» Group Buy : Passccielabs August release 2009
» Congrats!!
» 10-ccie-lab-tips
» ccie labs insider!!!
» Welcome Guest, please read about Access to forum
» RFC1925 - The Twelve Networking Truths